SONY's dealer to get it fixed. The units in the protect mode because the Microprocessor detects a large current being drawn by the amp. section of the reciver. This is a solid state unit and there are
STR-DE597 Display is not visible For a few years now my receiver has been working without problems. Recently I found that when the receiver was turned on it immediately went into Protect Mode, however
...sony str-de597. It was in the protect mode, but I repaired that with two transistors that were shorted. I now turn it on, and after clearing everything, it is stuck in headphone mode. I do hear audio ...
...SONY RECIEVER SRT-DE597 6.1 CHANNEL AND I ITS ON PROTECTED MODE CAN YOU HELP ME UN PROTECTED Amp output is damaged and needs repaired. Protect mode cannot be deactivated. When amp is repaired and ...
sony receiver The protection mode is there for a reason...the main one being to protect your speakers in the event that there is an issue with the amplifier. Bypassing the protection can easily result
Shuts down in protect mode Protect Mode keeps coming on disconnect all the speakers and turn it on. if it does not go into protect mode, then youve got a bad speaker or wire. good luck
...sony STR-DE 597 go in protect mode. how can I fix/repair this? Give me a tips. protect mode means there is a shorted components inside your reciever it's probably the out put transistors take out ...
...Sony STR-DE597 go into protect mode when the amplifier kicks on everytime I try to turn it on?? Two small resistors after the power supply have probably failed and will only allow safe mode ...
how to get stereo out of protect mode The wires to the speakers may be in the wrong positions check and make sure...
...protect mode have followed all the trouble shooting suggestions. Even with no speakers attached still goes into protect There's nothing more you can do. It is likely a shorted output transistor that ...
Usually answered in minutes!
6,442 Questions
5,455 Questions
4,073 Questions
2,449 Questions
2,268 Questions