Question about StreetPilot C330 GPS Receiver
solder and tape the battery wires to the connector wires where cut. Re-assemble everything and it will work & charge. Have you tried charging it with a USB? Garmin wants $150 for replacement. See link
...brute force. It will need to go back to Garmin for repair unless you are or know of an excellent solderer as the conenctions are minute. The case needs a TORX 6 screwdriver. These guys are really ...
USB cable and the car charger, but the battery doesn't charge. In fact, when on either "charger", the little battery icon doesn't even show up to show that it's being charged. I think I'm going to try
your computer usb port, you don't. 5. If you have a dead battery, Google DIY replacement. With some soldering it can done for $15 total. 6. If you don't have a dead battery, the issue is charging from
...top screen where to go I'm looking for a solution on how to adhere my USB port back into my NIkon Coolpix 2000 camera. Was considering just superglueing it. Is it necessary to solder a USB port
...USB thinking the battery might need recharging. However, the unit still does not respond. Its just dead!! Any suggestions?? If the unit is out of warranty, you have nothing to loose by opening it. If ...
...a similar problem. The USB connector broke off the circuit board. It's not difficult to repair. Remove the rear cover, remove the small circuit board and carefully re-solder the connector,
Question about StreetPilot C330 GPS Receiver
...red, green) also share the same plug as the speakers (brown, white). So you can guess that some soldering or taping of wires is involved. The battery can be purchased on Ebay. Should you need a ...
Question about StreetPilot C330 GPS Receiver
...Solder back the new speaker wires. 5. Plug in battery, reassemble unit and charge Garmin off PC wih usb cable. Done! Before trying to change the battery - Garmin says to try the following first: If ...
Usually answered in minutes!
889 Questions
381 Questions
310 Questions
95 Questions
81 Questions