Questions & Answers for: solder bridge

solder a bridge the on/off switch out of the circuit altogether? solder the two points on the back side of the switch together leaving the first one untouched. or desolder the switch and get a new one

...no good again. ANY HELP Thanks The IC is no doubt bad due to powering it up with the solder bridge. may possibly need entire convergence board unless you have the service manual and troubleshoot

...converge chipss and have sound bud no picture check to make sure none of the pins are bridged with solder this is very easy for the pins to become bridged. Check with magnifying glass to insure the ...

...still spinless? These replacement parts are shipped with a solder bridge to short the laser as a precaution for static electricity. Did you remove the solder bridge once the optics were installed? ...

solder bridge before trying to use the unit. This solder bridge is located on the new assembly's PCB. If you have the CDJ800, then the following will show you: CDJ800 PICK UP ASSEMBLY SOLDER BRIDGE If

...a few seconds before the red power indicator light started blinking. Any ideas? Sounds like a solder bridge bewtween the IC pins double check the solder for any pins accidentally bridged with

...lines of different colours with flickering. These span about 2 inches of the screen. This is a bad solder connection on one of the matrix controller chips on the LCD screen. You'll need to solder it ...

...solder bridge) and an illuminated magnifier or magnifying glass or microscope (to check for bridging) to re-solder these contacts down. If you aren't familiar with doing surface mount soldering, I ...

3 pin with 2 of the pins bridged) has come away and i don't know which wire (one black, one red) to solder to which pin. the charger is for a wheelchair The red wire is positive and is soldered to pin

soldering barcus berry bridge pickup which wires solder to which prongs Solder the white wire to the shortest terminal and the ground/exposed wire to the outer/largest/ground terminal.