...lamp doesn't work. I replaced the bulb, and after 2 days, it went out again. If I switched the bulb to the right side, it would work on the right side !! So, my guess is it's something to do with ...
...but all lamps are good. Grateful for your thoughs. . .thanks. . . chances are it is a loose socket or wire going to the socket it. to check this just turn the signal on and wiggle it this ...
...lamp socket by turning counterclockwise. To Install: Install the tail lamp socket by turning clockwise. Connect the electrical connector to the tail lamp assembly. Position the tail lamp assembly to ...
2004 buick century blows tail lamp fuses i have a 2004 buick century that blows fuses for the tail lamps. brake lights still work though. Replace the socket of the bulb. It's shorted out.
...socket , front lamp bulb holder, even a towing socket if fitted etc . Finally a bad earth connection will not blow fuses unless the wire is completely detached and floating around the lamp cluster. ...
...socket assemblies to the back of the lamp unit. Install the lamp assembly to the vehicle with the mounting screws. License Plate Light Remove the lens screws. Once the lens is removed you, can access ...
...Lamp Module. I will say, however that I have seen quite a few problems with the headlamp bulb sockets on several of the
lamp socket. With the test light properly grounded it should flash like a turn signal. If you have no power at the socket you have an open circuit (broken wire or bad connection). If you have power at
...one in it sparks and blows i had this problem b4 check where you stick the tail light bulb in that socket for the might be burned out. i suggest checking front as well one of them probably has a bad ...
Usually answered in minutes!
921 Questions
813 Questions
785 Questions
797 Questions
687 Questions
