Questions & Answers for: Subaru socket for lamp

...socket My 2001 Forester has one headlight lamp that is intermittent. I can jiggle the 3-prong socket and get it back on, but then if I turn the lights off and then back on, the headlight remains off. ...

...lamp and noticed part of the socket had melted and cracked. Checked internet for socket and hoping I wouldn't have to spend big bucks for whole light assembly just to get the socket part. No luck. So ...

...lamp by pressing it slightly into the socket and turning it ccw just a small angle and the bulb will sping out. Installation is the reverse. If this is a wagon, open the rear hatch, and behind the ...

...lamp then you could have missed the socket that the motor attaches to. regards John That the right place to attack. Its tedious job but for each movement keep only that motor active, disconnect the ...

...side head lamp because the low beam is not working. any solutions for this problem? check the sockets maybe there is not a good contact and burning the bulbs, also check the connectors the the ...

lamp works fine ... any clue? Check the bulb, socket interface, clean contact points. IF you have a test light or ohmeter, check for power to the socket. If unpowered, check the fuse, if powered check

...head lamp. Moisture building up in the head lamp can cause this. If this is not the case, you may have a bad wire in the harness. Check closely around the bulb socket and test all wires for

...an inch or so back from the socket. If wire(s) have power replace socket. If not, and even if you find power on the pins but the lamp doesn't work, then also check for a bad or loose ground

...lights on with the headlights offThe stop lamp that turns off when the brake pedal is pressed has been jammed into the socket backwards (it happens!) or the black ground wire is disconnected or ...

...on the supply wires. The lamps may (and often are) rusted and the bulbs are not grounding in the socket. If there's no +12v, then look for a blown