Question about Pixma iP4500 InkJet Printer
...cartridge to the printer is not soak).. Place the printhead on the hot water and leave it there for about 4 to 5 hours..move it on different location from time to time..After soaking, rinse it with ...
Question about & One Handle Tub & Shower Faucet
minerals in the water causes it to stick. You can replace the cartridge or try cleaning this one by soaking it in white vinegar. When the cartridge is clean you should hear it rattle when you shake it
...cartridge to the printer is not soak).. Place the printhead on the hot water and leave it there for about 4 to 5 hours..move it on different location from time to time..After soaking, rinse it with ...
Question about MFC 420CN All-In-One InkJet Printer
...cartridge to the printer is not soak).. Place the printhead on the hot water and leave it there for about 4 to 5 hours..move it on different location from time to time..After soaking, rinse it with ...
Question about Photosmart 2575 All-In-One InkJet Printer
...cartridge to the printer is not soak).. Place the printhead on the hot water and leave it there for about 4 to 5 hours..move it on different location from time to time..After soaking, rinse it with ...
Question about Airwasher VS 207 3.7 Gallon Humidifier
Do I have to soak the new mineral cartridge before installation? Yes, for at least 1/2 hour.
...Soak cartridge in a 50/50 vinegar and water solution for 24 hours to remove any mineral deposits. **NOTE** Unless both hot and cold water supplies are turned on, the pressure balance valve will allow ...
Question about Hamilton 4 In. Centerset with Speed Connect Drain,Polishe
...from faucet Most likely the screen at the end of the faucet is plugged with a mineral deposit. Unscrew the screen cartridge from the end of the faucet and soak it in vinegar to dissolve the
Question about Hamilton 4 In. Centerset with Speed Connect Drain,Polishe
...cartridge. Soak the faucet in white vinegar as long as needed to dissolve minerals / hard water deposits. Scrub with an old tooth brush as needed. Check the directions for installation of your ...
Question about 100,000 BTU Pool Heater H100ID1 - Above Ground
...Cartridge Cleaning soak overnight. Same thing with a Sand Filter, Backwashing is not enough, use Sand Filter Cleaning product and allow thorough cleansing soak overnight. Anything that will restrict ...
Usually answered in minutes!
1,392 Questions
801 Questions
725 Questions
572 Questions
453 Questions