Need to purchase SMD Tactile Switch(es) One of the SMD Tactile Switches broke and I need to purchase one to repair it. I have an SMD soldering air station, but I need to know where to find this type ...
...lens with isopropyl alcohol or acetone. if there is no change, the chances are that there is an smd fuse that is open on the AtoD board. the consumer cannot access this component. Many times this ...
...at thisPhillips/Maganavox TS3258 Dead, HOT shorted R&R Flyback, HOT Transistor,#3610- 22k, #6328 SMD diode, #7325 SMD Transistor and Check #3611/3608 190 ohm resistor by #3610 TELEVISION MAGNAVOX ...
...dv6500 it had same probs as mentioned above the probs i found : shorted schottky diode marked LG = smd10k45 shorted n-ch mosfet marked 702 = 2N7002 defect smd cap All these are placed just below the ...
My Roland KR 650 digital piano, amplifier has a load hum and will not play. smd elkos on the mainboard is defective 10uF16V and 3,3uF types Are all smd defective?
need repair kit for bn44-00307a Transistors QX801 and QX802 SMD resistors RX802, RX803, RX832, RX833 (all with the same value) SMD resistors RX804 and RX805 (same value) SMD diodes DX803 and DX804 ...
...is damage/burnt at Transistor Q4 or Q3 or both. Usually followed by R8. Replace it. Q3 = BC337 (SMD marked as 6C) NPN. Q4 = BC327 (SMD marked as 5A/B/C/D) PNP. R8 = 470 ohm (SMD marked as 471). .
...of resistor 601 burn resistor 600 ohms A resistor with a number code instead of a letter code is a SMD: Surface Mount Device. You might have searched for SMD resistor code and got some hits. The ...
Question about G2 MultiEffects Guitar Pedal
What is the difference between GLC-LH-SM and GLC-LH-SMD? They are 1000BASE-LX/LH SFP for Both Multimode and Single-Mode Fibers, compatible with the IEEE 802.3z 1000BASE-LX standard, operates on ...
Usually answered in minutes!
1,383 Questions
1,133 Questions
959 Questions
944 Questions
808 Questions