Questions & Answers for: Subaru Forester smart sump plug location

...cover over everything, so I can't find the drain plug or oil filter location. remove bottom cover under car the filter is at the bottom of the engine as is the drain plug for the sump ,very easy to ...

Ad

where is the knock sensor located on a 2001 subaru forester engine 4 cyl. Replaced wires and plugs ...runs great but sensor does not reset and comes right back on after code is erased. are they a one ...

Ad

Question about 2004 Forester

1 Answer

makes grinding noise going uphill Have you checked your front & rear differential fluid? for the front, there is a small stubby yellow dip stick on the passenger side in the rear of the engine. It

...plug location, where is it. All diagnostic plugs in newer cars and trucks are under the dash/ drivers side, could be in fuses, by the hood release, up by steering column, Keep looking you will find ...

the ABS light stays lit on my 2000 Subaru Forester. I have replaced front disc pads and rear shoes (drum brakes) appear to be in good shape. Master cylinder is ok and there are no fluid leaks anywhere

Question about 1998 Forester

2 Answers

1998 subaru forester , bad gas mileage ,,maybe the oxygen sensor? where is it located,thanks did any one ever change the motor in that car cause if so they hooked the vacuums up wrong had same issue ...

Question about 2001 Forester

1 Answer

where is the knock sensor located on a 2001 subaru forester located? the knock sensor is under the manifold on the right side. It has a bolt that holds it in place and usually a small white plug under

Question about 2007 Forester 2.5X L.L. Bean Edition

2 Answers

do you check the oil level when the engine is cold or hot If you check it cold with the engine not running you get an accurate reading of the amount of oil in the sump; otherwise oil will be ...

...plug on this vehicle? The location is a on the bottom of the engine block, just above where the oil dipstick enter the oil pan. If it does not have a block heater already installed, there will be a ...

Neutral position switch circuit low input there is a switch unit on the transmission that reads the position of the shifter. This fault can be from damaged wiring or a poor connection in the plug from

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...