Questions & Answers for: slide plate

...plate when a slide is being projected. And this plate is VERY slow to pivot back to push the slide against the fixed plate. I suspect that the slide is being ejected before it is properly positioned ...

How do I put chain back on? the chain guide plate has slots at the mounting frame,slide chain along plate,put slots over the bolts engage chain on sprocket,slide plate outwoulds to tension the chain

...pushing on the battery under the plate) and slide the plate down toward the silver speaker, once it slides all the way down you can lift the plate off and have access to the battery and Micro SD

...slide in to bell housing the trans is lined up but having problem sliding in. it stops about an inch from sliding in but will not . Your problem is probably that you have the clutch plate out of ...

cant slide the needle plate setting knob over for rolled hem trying to do a rolled hem on janome mylock 744d , needle plate knob wont slide forward Does it have another plate for rolled hems?

...slide plate on my Singer 416? I removed the slide plate on my Singer 416 to loosen the bobbin tension. Now I can't figure out how to replace the slide plate. Can you help? Lift the sewing machine ...

my slide plate is too loose how do i tighten it? the slide plate keeps opening when i am sewing most from underneath the plate. take plate off, tighten screw, replace

...slide plate and reinstall it? Proper way to take off slide plate that is over bobbin case and then put it back on. For most machines, this is just a matter of opening it about 3/4 of the way then ...

slide plate. How can I reinstall it? This can happen easily on older machines if you pull out the slide plate a little too far. If the bottom of the slide plate has a flat spring that should have keep

...slide plate on a singer 6234 1st. remove the foot from the machine to give you working room. 2nd. get the long plate "throat plate" look at the under side, you will see 1 side the slide part crimp ...