Question about 500GB Maxtor Diamondmax21 SATA2 Hard Disk Drive 7200rpm 16MB STM3500630AS 500 GB SATA Hard Drive
slave jumper setting the drive only has 4 pins. i cannot find the jumper settings to make it a slave drive. SATA drives don't have jumper settings. You can set master/slave in BIOS. just simply put ...
Question about Barracuda 7200.10 500 GB SATA Hard Drive
Barracuda 7200.10 (how to make it slave) The map isn't on this model of hard drive. I need to slave it out but there is no mapping on the hard drive like you would normally find. Seeing as different ...
Question about Barracuda 7200.9 ST3400633A 400 GB Hard Drive
How do to install slave drive Seagate Barracuda 7200.9. Does it has to be to the motherboard or to a card in my computer? How do I set the pins in what order? if y0our going to slave one hardrive you ...
how to make IDE slave hard drive? how to make this device IDE slave hard drive? Seagate U6 (ST340810A) 40 GB Hard Drive You can make it slave with jumper settings check in back side of harddrive you ...
Question about U6 (ST340810A) 40 GB Hard Drive
...select means if you connect your harddrive to middle socket of ide cable and then it detects it as slave but if you connect it at the end of ide cable it detects as slave.But make sure that otehr ...
I need to put my hard drive into an enclosure but I cannot figure out if I need to switch it to a slave before adding it to another computer i have done this alot for my customers and its really ...
trying to make my seagate barracuda 7200.9 slave 1) Open your computer case 2) On the back of the drive where the connectors are, you have jumpers. These small plastic tabs change the function of your
how to connect it as a slave. there is no guide to follow on hd label During the boot process you will see on the screen to press a certain key to enter setup Press and hold that key during the boot ...
Question about Barracuda 720010 hard drive 80 GB ATA100
jumper position for slave operation pleasekevinmcc@austarnet for slave removed all jumpers. During the boot process you will see on the screen to press a certain key to enter setup Press and hold that
Question about Barracuda 7200.7 ST380011A 80 GB Hard Drive
Installation of the drive and setting of jumpper to make it either as a master or slave During the boot process you will see on the screen to press a certain key to enter setup Press and hold that key
Usually answered in minutes!
600 Questions
303 Questions
161 Questions
116 Questions
84 Questions