Questions & Answers for: sit and spin Vacuums

...spinning by moving them while the unit was running. For mine it seems that they got stuck from sitting. The brushes move from the air driven motor unit. This works from the vacumm that is being ...

... Thanks, On the bottom of the tank is a valve, push it in and see if water comes out Where the tank sits, there is a black round seal, is it in the proper place? The rod in the handle hits just under ...

...of dirt, but the yello spinner-blade-like thing is not spinning, and my dirt is not spinning, just sitting there in a pile getting bigger and bigger......I doublre triple checked all connections to ...

...2 longer ones, they got into the turbine, turn it upright and take the top cover off. The turbine sits near the front, center, remove the 2 screws on the front of it, remove the hoses, then you can ...

spin there is power at the two metel pieces that sit perpindicular to the magnetat the motor . But it wont spin. Is ther an inner fuse that burnt? Most likely the carbon brushes are burnt out and need

flow indicator not spinning if you took it out you might not have put it in right the small round white piece with the little thing sticking out of it needs to facing up and the red thing that spins ...

I followed the trouble shooting advice for a Hoover steam vac that has non-spinning brushes. Turbine ordered and replaced. Female receptacle still is not spinning. What now? There could be several ...

...brushesThey are located at the very end of the brush They are probably missingor they snapped and sitting in the housing somewhere. If you ar mechanically inclined not very difficult to replace. ...

...spin free or hesitate or not turn at all? If it spins with effort there could be debris under the end caps; if one end cap will not turn there is enough debris to cause the end cap to internally melt ...