...cover side. I guess I could use my Channel-Loks, but there must be a gentler solution. It is only six screws, and you have to GENTLY wiggly the front cover off....Start at the bottom, and wiggle side ...
...side cover that has the functions buttons (focus, nightshot, ect). You need to support the lens and cover as they are connected with a thin copper strip. Once off you tighten the 3 screws on the left ...
Question about VAIO Digital Studio PCV-RX550 PC Desktop
side cover? How do I remove the side cover on a Sony Vaio PC-RX470DS? On Sonys, you have to remove the top cover first. Look in the back and you will see 2 tabs. Pinch them together and remove the top
Question about Grand WEGA KDF-50WE655 50" Rear Projection HDTV
...side of cover should pop loose. Do the same on the left side. Next pull gently at the bottom of the cover near the center. Cover should come off now. Once the cover is removed you should see a cover ...
Question about Grand WEGA KDF-42WE655 42" Rear Projection HDTV
...cover from top side towards you (watch your fingers is really hard to make this operation you need a strong fingers) note: the bottom is trapped with another inner plastic obstruction. Now with this ...
Question about Grand WEGA KF50WE610 50" Rear Projection HDTV-Ready Television
cover on side of tv remove in reach in side (MAKE SURE UNPLUGED FIRST) ther is an other cover(SAFTY COVER )in side with a leaver on it turn ant-clock wise and pull out now reach in and feel for finger
Question about VAIO Digital Studio PCV-RX580 PC Desktop
...Side Cover You must remove the side cover to access the system board, add-in cards, power supply, battery, memory, and internal drives. 1 From the rear of the unit, pull the metal tab shown in the ...
side of the console there is a small plastic cover. Using a small flat blade screwdriver, carefully prise one end of the cover outwards. There is a small cut-out on one end where the screwdriver goes.
...cover towards the left side of the PS3(where you just removed the sticker) and lift it off. 4. There are 8 screws holding a second plastic cover down. Unscrew them with a Phillips head screwdriver, ...
cover and undo the two screws. 2 - On the front of the remote down the bottom there is a slider that covers some additional buttons. Slide that down then twist/lift/pull until it comes over. Be gentle
Usually answered in minutes!
1,133 Questions
959 Questions
541 Questions
528 Questions
411 Questions