Questions & Answers for: show starter

...starter draw is too high. At this point problem may be intermittent though and may not show up. If wiring is intact and shows no evidence of shorting to ground, It would be a safe bet to change ...

Ad

...If it cranks over, the relay is bad. If it doesn't, check power at the starter while holding down the start button. If you show power at the starter, the starter is bad.(or the engine is locked

Ad

Question about 2004 Explorer

1 Answer

will not start Battery shows 12.47V, but starter will not turn. Tried jump-starting, not effect. Lights seem strong, though dome light dims while trying to engage starter. Sounds like a dead starter ...

starter motor I can't show graphics but I can tell you how, firstly locate the starter motor, remove the battery lead from the starter motor,plus the small lead from the solenoid then remove the bolts

starter relay click and you should show batttery voltage at this connector. If you do NOT show and voltage at that wire, replace the relay. If you DO show voltage, your problem is in the starter. Good

Question about 1999 Camry

1 Answer

...show 12 volt.But if battery is showing 12 volt.Then check the battery to starter connection.If that is also checked ok then check voltage for starter itself.The starter is also a 12 volt part.But if ...

...a test light grounded to engine block and probe the relay terminals. Should only have one terminal showing power. Now have someone hold the key in start position. Now you should have two terminals ...

show the tests, all great books on starter repair cover this. in a pinch ive even repaired a solenoid. ask. for the tests. and steps. but with zero symptoms , id be forced to show all tests. all steps

starter needs to be replaced show me a diagram with the location of the starter Enter all your information on "You Tube" and there should be a video showing the process. If not and you are close to an

...with a volt meter and make sure it puts 12 volts to the starter when button is pressed. If meter shows 12 volts then the stater probably needs starter cable lugs tightened, new brushes or the

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...