Questions & Answers for: shiny printer paper side down

not dry HP C5180 - After photo prints, the ink never dries. I am using HP paper in the correct order (shiny side down). 4 x 6 Kodak xtralife paper- Hp ink and the photo will never dry and is all blury

...any slots inside the machine as you might expect. Just put shiny side of paper down, feed edge of roll out of machine and under the roller that is attached to lid, and that is all there is to

...Printer out of paper.? The paper trays are empty or overloaded.The paper is curledThe print side, or shiny side, of the paper is not loaded in the input tray face down.The paper might not be engaged ...

...printer in the correct orientation (shiny side up), close the lid and print again. I've discovered even better results by keeping the special blue sheet that comes with each paper pack. I run the ...

...to load paper glossy side down even when full j ust off of photo tray It's telling you to turn over the paper so that the shiny side is down. The back side with the stripes and logo should face

...printer on. The paper tray is empty or overloaded. The paper is curled. The print side, or shiny side, of the paper, is not loaded in the paper tray face up. For photo paper, always load the rougher ...

...shiny)side is down, w printing facing up. I keep getting check your tray. Printer works fine on paper8.10 reg for printing documents etc. but wont do 4x6 photos.Easy share 5100 is the model.It is ...

...printer (the shiny side or plain side?) And what to do if the paper gets stuck or does not come out of the printer? Does the blue paper go in with the white printing paper? the shiny is face down in ...

...paper is supposed to lay! For front or front tray loading printers, shiny side down... for rear/back loading printers.., shiny side up.  Pictures should be visible coming out of the exit slot. ...

...shiny side of the paper towards you. Lay the paper in the printer and close the printer arm down onto the paper. If you are setting the journal side, wind some paper onto the takeup spool after it ...