...sharp 20 tv shut down some times some times it work for 4to5 hours before it shut down and other time it take longer My problem was not overheating, it was a circuit board issue. They replaced both ...
...Sharp HDTV flat panel and I'm having problems programming the remote that came with my comcast digital cable box. If you could please advise me I would appreciate it. Thank you. I am having the same ...
...Sharp 21V-FP85S: Shuts down after few seconds but the pilot light remains on. I almost soldered all the parts but it did not work. I hope you can help me fix this problem. I replaced the the power ...
Question about LC-13SH1U 13 in. LCD Television
...Sharp LCD TV is about two years old and is made in China. Picture comes up looking normal but tv shuts off after three seconds. I can't see any solder fractures or cracks on the main board. The ...
Question about LC-13SH1U 13 in. LCD Television
...Sharp X Flat TV Model 27F630 either won't come on when you press the power button or if you unplug it for a minute or so and then plug it back in and press the power button it will come on for a few ...
...tv on and after a few seconds it shuts itself back off again. At that point I can't turn it back on until I unplug it and plug it back in. However, when I turn it back on it will again turn itself ...
Question about 27K-S100 TV
Sharp LCD TV doesn't turn on after a shut off. I Then have to unplug the TV. After a few hours I reset by hold the -Vol, -channel and power buttons downs for 10 seconds plug the TV back on and
Question about 27K-S100 TV
...Sharp CRT TV turn on then click off a few seconds later? When the power switch is pressed the VCC 9v is measured on the 56 pin IC TB1253AN but not after a few seconds.On pin 32, the x-ray pin, about ...
Question about 27K-S100 TV
Sharp Aquos LC C5277UN 52" LCD TV 1080p: TV turns on via cable DVR; TV picture comes on for few seconds, then turns off. Then Power and OPC lights flash repeatedly. Is there a solution to the problem?
Question about 27K-S100 TV
...sharp lc-32a37m lcd tv it switch on but only stays on for a few seconds then it goes on stanby could it be the power supply Chances are good its the power board..you can test the voltages after it ...
Usually answered in minutes!
2,410 Questions
2,254 Questions
1,646 Questions
1,423 Questions
1,438 Questions