...TV turns off automatically after just a few seconds. If I unplug and replug it in, it re-sets and I can turn it on again. This worked for several months but now it never stays on for more than a few ...
...CRT TV. The set has a beautiful picture (rich color, sharp ...). BUT after the TV has been on for 30 seconds or so, the picture fades and the left side crumbles and then the picture disappears and ...
Question about 25R-S100 25" TV
...tv wont stay on for more than a few seconds when powered up. it turns on but then almost immediatly shuts down, then it wont do anything at all. i can unplug the tv then plug it back in, and it will ...
...Sharp 21V-FP85S: Shuts down after few seconds but the pilot light remains on. I almost soldered all the parts but it did not work. I hope you can help me fix this problem. I replaced the the power ...
...tv on and after a few seconds it shuts itself back off again. At that point I can't turn it back on until I unplug it and plug it back in. However, when I turn it back on it will again turn itself ...
TV Shut's off and won't come on unless I unplug the power cord for a few seconds. Then it works OK. Check for bad connections or loosely soldered pins on any connectors and any other components ...
...tv stays on a few seconds & then shuts down pull out the plug and whilst pressing the Vol-up and Ch-up buttons at the sametime, plug the AC cord into a wall socket,the set will stay on,test your ...
crt) this causes a sharp increase in beam current and the power supply shuts down into standby mode. To prove the point isolate the red and green cathode pins on the tube base and cross couple the red
...CRT-(tv tube) design,tv have cold solders joints alots.If used like years in years out tv in used daily.U have a soldering iron,a roll of solders,can u do basic soldering also? Yes.Take the tv aparts ...
Question about 27F543 TV
...Sharp CRT TV turn on then click off a few seconds later? When the power switch is pressed the VCC 9v is measured on the 56 pin IC TB1253AN but not after a few seconds.On pin 32, the x-ray pin, about ...
Usually answered in minutes!
2,410 Questions
2,254 Questions
1,646 Questions
1,423 Questions
1,438 Questions