Sharp AL-1631 Out of Paper Copier unable to pick up paper. Also its making a clicking noise. Any ideas? Could be quite nasty, that one! Open RH side door, Is there any obvious spill ot toner, ...
...Copier makes a screeching sound. Paper feeds through. No lights come on to indicate toner or drum problems. Goes through start up check normally. this noise could be coming from the by-pass , because ...
...sharp al 1631 makes clicing noise and does not scan, also it doens't move the light across the glass Sounds like your scanner is jammed or the scanner motor has failed. If you are so inclined, turn ...
...sharp copier AL 1631- it's making a noise i have a sharp copier AL 1631- i just replaced the toner with a refill... it's making a noise when i turned it on and when it copies...i read one of the ...
Making A lot of noise noise is usually in the fuser section of the machine, it needs to be removed and checked. Check the gears where the noise is coming from.
making a grinding noise up front but still copies fine hi need service
when i close the back door it is making a loud noise. sharp al 1631 If it sounds like gears grinding it may be the fuser unit. The bushings and gears need replaced or new fuser unit.
...Sharp AL series machine just run and run it means they are low or out of toner. This is especially true if you are hearing a light thump thump noise while it is running. Just let it run and after 5 ...
...Sharp AL 1631 copier press the following key's in sequence and as quickly as possible (with 4 seconds for the first 4 keys) Press "C" then the far left key (exposure mode) then the "C" key then the ...
...makes a loud clicking noise , until you turn it off. We just had the tech look at ours for the same reason. The Drive Assembly is shot. A new assembly unit will cost over $200. Not worth fixing. ...
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions
