..., if there is oil leakage around the plugs and inside the plug wells When you buy the valve cover set, it will include the spark plug well "O" rings. Simply remove the valve cover and on the ...
...off the valve cover and if so, what else needs to be changed? O-rings, gaskets? Is there a torque setting for the valve cover? Well i wouldent of thought you need to take off the valve cover AKA ...
...seal.take off the valve cover and inspect the seals they are probably no good.there are 2 seal sets,one is in the valve cover,and that results in oil on the outside of the plug,and the actual ...
...the valve cover gasket and the spark plug well seals which come with the new valve cover gasket set, use a FELPRO brand gasket set much cheaper than a factory set and equal or better
valve ajustment intake exaust valves Adjust valve clearance Intake COLD ENG set to 0.21mm (0.008") Exhaust COLD set to 0.23mm (0.009")
ga14 valve clearance valve clearance and procedure for setting GA14 NISSAN SENTRA model 1988 no rocker arm direct to cam lobes all intake and exhaust valve. what the procedure to adjust the between ...
...set to .012" inlet hot and .014" exhaust hot position no 5 piston when there is valve rock(overlap) and do no 1 valves. position no6 piston valves in overlap and do no3 piston valves and so on in ...
Question about 1988 Sunny
Cylinder Head Torque settings for Nissan NP200 with 8 valve K7MF710UD engine I am looking for Cylinder Head Torque settings for Nissan NP200 8 valve K7MF710UD engine look for the service manual Need ...
tappet settings for Nissan almera 1.6 2006 model Intake valve 0.304-0.416 mm (0.012-0.016 in) Exhaust valve 0.348-0.472 mm (0.014-0.019 in) Hot engine set this setting. Regards Geoff
Usually answered in minutes!
1,587 Questions
1,450 Questions
1,309 Questions
1,122 Questions
1,306 Questions