Questions & Answers for: Chevrolet S 10 set timing on engine

...set the timing on the truck YOUR ENGINE DOEN NOT HAVE A TIMING BELT IT IS A CHAIN.REMOVE THE DISTRIBUTOR CAP AND SEE IF THE ROTOR IS TURNING WHEN THE ENGINE IS CRANKED OVER.IF NOT THE CHAIN OR ...

...set timing" connector. This is a single wire sealed connector that has a tan with black striped lead. The location of the "set timing" connector with a Powertrain Control Module (PCM) controller is ...

set timing on a 1987 chevy c10 The decal under the hood is the best place to look for the specific instructions, but depending on which engine you have you will need to disconnect a wire terminal, and

timing is properly set, hold the distributor to keep it from the turning and tighten the locknut. Check the timing again after finishing with the nut in case the distributor moved as you tightened it.

...Set the timing where you want it to be, then turn off the ignition and re-connect the wire to the electronic timing control. Re-start the vehicle and the check-engine light should go out, that is of ...

...set the timing on a new engine?I installed a rebuilt 4.3L W type and cant get it to fire.Do I Have to disconnect a wire to time it? Hi there is a tan/black wire it should be just above the carpet on ...

...set timing on these vehicles there is usually a vacuum line that runs to the Distributor assembly that needs to be plugged when setting timing. This is because it off sets the advance when setting ...

...set the timing marks in accordance with the manual. if the engine is interference type, you probably are going to need new valves and a used engine with lower miles would make more sense than doing a ...

...set Timing or how to. Just put new head gasket on and fuel is filling up 1 cylinder wall. The 2.2 is known to "strip" the timing gear. The cam gear is made of a synthetic material. But...you could ...

...set the timing on my 98 chevy 350 vortec You actually can't advance or retard timing on your truck without pulling the timing gears off and manually doing it. however, if you adjust too far you can ...