Question about 2004 DT 125 R
...clean and dry the air filter and install the carb. Let the float bowl fill then start the engine. Set the idle speed with the idle screw. This process should get you back on the road unless other ...
...any scratch for a possible blow by, and have parts replaced if possible. for the carburator, just set the timing and the tuning to 1:4:5. should you have other questions, please let me know.
...set to ****** the power after 7k revs. source a pre1996 c.d.i. 3.the power valve, this is on a servo that controls its postion at a given point in the rev range,this is desinged to give a ...
...bolts in a pattern, a bit at a time, and you DID use a torque wrench, didn't you? The timing is pre-set, you have no points or condenser. You may have messed up the timing by trying to adjust it. Can ...
...set the points gap at .012 to .015 and you should be about right. The gap is set with the arm riding on the high point of the magneto center lobe. Please take a moment and rate my answer.
...behind the magneto. one feeds the lighting and battery for the bike. the other should run through a set of points, through the coil and then to the spark plug. you should not need a battery at all to ...
Usually answered in minutes!
165 Questions
73 Questions
43 Questions
22 Questions