Question about OptiPlex GX260 PC Desktop
What is setting the pc back to factory settings mean? Dell tech. support was called as the dell desktop acquired a virus that could not be cleaned by mcafee (current dats) nor qwest. Dell finally set ...
Question about OptiPlex GX150 PC Desktop
loads windows set up then re boots and bios states loads windows set up files-- then re boots and bios states it cannot find hd 0 then 1--- why would windows set up and load the set up files then ...
how to restore to factory settings reset computer to factory setting You Hit F2 when The Computer Is Booting Up then You Go into The BIOS And Somewhere In there It Should Give you The Option To Set ...
mic issues my pc doesnt recognise my mic and in volume control mic settings are greyed out i am using delloptiplex240 and soundmax card my speakers work absolutely fine you need to go to settings in ...
Dell GX110 not booting from CD Problem Have you set BIOS to Boot from the CD/DVD? If not please do that. You may need to set your CMOS boot priority to 'boot from CD drive". Put your boot disk in the ...
my dell optiplex 360 pc is not boot properly, and date and time is not set. Now white I do? If you start by going into the BIOS settings, set time and date then make sure it detects your hard drive ...
chipset heat sink not detected The chip set heat sink is not properly installed on the system board. Ensure that chip set heat sink is properly installed on the system board. To locate the ...
Question about OptiPlex™ GX270 PC Desktop
I am in need of a list of the BIOS settings for a Dell Optiplex GX270 Attempting to restore a Dell Optiplex GX270. However I need a list of the BIOS Settings as it tells me there is insufficient ...
Question about OptiPlex GX620n PC Desktop
I have a dell and it said that i had a chassis intrusion I dont know what it means nor what to do help I dont know what it means nor what it is help That just means the case of the desktop was opened ...
Question about OptiPlex SX280 PC Desktop
...at the Main Menu, then select OFF at the OSD Lock option. Select Exit to save the setting and exit the menu. hope this ...
Usually answered in minutes!
848 Questions
511 Questions
428 Questions
382 Questions
349 Questions