Questions & Answers for: i sensor means


Question about 2002 Optima

3 Answers

...sensor is defective, it means there is a problem in the crank sensor circuit, that can be the sensor, the sensor connector, the sensor wiring or in some rare cases the PCM (computer) it also could be ...

Ad Bank 2 Sensor 1 Bank 2 means it is located opposite of where cylinder 1 is (not sure where cylinder 1 is on your car) and Sensor 1 will mean it's the sensor located before the catalytic ...


...means the sensor is located on the same bank of the engine that has the #1 cylinder. B2 is located on the opposite bank. S1 means the sensor is located BEFORE the catalytic converter S2 means the ...

...circuit, code p0141=O2 Sensor Heater Circuit Bank 1 Sensor 2 that means its an oxygen sensor located in bank 1 which is the drivers side,sensor 2 means its the downstream sensor after the ...

...means Bank 2 Sensor 2 Heated Oxygen Sensor (OS) heater circuit is bad. On the surface this could mean that the OS located closes to the exhaust, after the cat converter, before the muffler is bad. ...

Question about 2000 Montero Sport

1 Answer

...side of the engine bank 1 is the side that #1 cylinder is on bank 2 is the other side sensor 1 means upstream above the catalytic converter on the engine side sensor 2 is below the catalytic ...

Question about 2004 Stratus

1 Answer

...SENSOR 2 means it is the down stream 02 Sensor. This means that the sensor that's close to the engine is sensor 1 and sensor that's farther away from the engine is sensor 2. Hope this helps and have ...

sensor is reading that the exhaust has too much oxygen in the exhaust thus the engine is running lean witch means you are not getting enough fuel or touch air. could also mean you have an exhaust leak

sensor. 1/2 means, "Right Bank" Downstream 02 sensor. 2/1 means, "Left Bank" Upstream 02 sensor and 2/2 means, "Left Bank" Downstream 02 sensor. Hope this helps and please visit my auto-repair-website

temp sensor. Now if it code P0133 then the cause would be an O2 sensor. Which is bank 1 sensor 1. In some cases on older vehicles code 13 means there are no problems but that was back in 95 and before

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts


Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

john h

Level 3 Expert

23424 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides