Questions & Answers for: sensor drum

Question about FP-7735 Black and White Copier

1 Answer

...drum sensor. if the Drum cleaning blade (DCB) has failed and is smearing toner around the drum then the drum sensor can't see the drum. clean it with a brush. the sensor sits in the drum/ cleaning ...

Ad

Question about AR-C160 Color Copier

1 Answer

...Drum Mark sensor, re-seat all connectors between the sensor and the process driver PWB. Recalibrate the DM sensors using simulation 44-02 (press execute). If F2 error still occurs, replace DM sensor ...

Ad

Question about AR-5320 Black and White Copier

1 Answer

...sensor and drum surface for contamination. F2 32 Content Process control trouble (drum marking sensor defective) Detail Usually the sensor gain is adjusted so that the output is a certain value, by ...

Question about AR-5320 Black and White Copier

2 Answers

...drum potential sensor and clean.2) change drum potential sensor board (drps board)..3) check HV contact (located at back side of the processor unit)..4)check carona grid mesh and clean it..5) color ...

Question about AR-5320 Black and White Copier

1 Answer

drum replaced drum but still says need new drum Check the sensors around the drum if thy are okay, replace faulty sensor, reset the drum. if the fault persist replace the drum.

Question about EP4000/5000 CS/PRO Copier

1 Answer

...drum area there is a sensor that monitors the drum. it is part of the house keeping procedure if the sensor gets dirty well copier will do nothing until the sensor reports OK. So recommend that you ...

Question about Phaser 8860MFP Printer

1 Answer

...diagnostics, run the Drum Temperature Sensor test. If it fails, replace the drum temp sensor. If that doesn't solve the problem, replace the sensor wire harness. 130K75210, Drum Temperature ...

Question about bizhub 750

1 Answer

...drum sensor that monitors the drum, and the surrounding area. also has the developer and drum been replaced.to clean the drum sensor the drum must be removed. do not use a vacuum cleaner as static ...

drum and clean the sensor that monitors the drum. it will have a small with cover the clear cover sensor is for paper jams. be careful do not put your fingers on the drum if that does not fix it order

drum unit's sensor. The sensor is responsible for telling the printer that the drum unit is correctly installed and ready for use. Here are a few steps you can try to troubleshoot the issue: Make sure

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Office Equipment & Supplies Experts

k24674

Level 3 Expert

8093 Answers

Brad Brown

Level 3 Expert

19187 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66931 Answers

Are you an Office Equipment & Supplies Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...