...front load washer that fills up with water when the washer is shut off. Any idea what is causing this...? Jamesbestor, The water fill selenoid had junk in it holding the valve open or the seat in the ...
Question about GHW9100L Front Load Washer
...front load washer water will enter the fabric softener but the fabric softener will not go into the washer. this has selenoids on it you will have to ohm them out and if you dont get any readings on ...
Question about GHW9100L Front Load Washer
...Front Load Washer: my machine is leaking, i been told that that part ... My machine is leaking i been told that that part is called water selenoid is that right? Yes that could very well be your ...
...load. Then it gradually starts to fill while it sits. What could be causing this???? The selenoid valve has some trash in it. Take the valve off of the back. It should be just a few screws, a couple ...
...selenoid. It has a sprig that pulls the safety latch back off of the latch. Either it isn't turning the power off or the spring is broken or too dirty with soap and wont work right. Try pulling the ...
Question about Axxis WFL 2060 Front Load Washer
...washer wfl 2050/ 2060 door is locked and will not open Tom Unplug it from the power source. It should release it if not you have a sticky selenoid that locks your system. If freed. great.. but you ...
Question about Neptune MAH5500B Front Load Washer
dont pull the water selenoide good fus gud dont pull the water selenoide good fus gud Hi from retired Englishman in SW France, This is symptomatic of a malfunctioning water control valve- the hot ...
...front load washer does not use cold water when cold cycle is selected. Either the cold water valve selenoid is not working or the control panal is bad. try swapping the hot and cold hoses and then ...
...Now it won't get water on rinse cycle. I have troubleshooter all I can. Please help Check wire to selenoid water valve. Could be burnt out selenoid if run wit water
...front loading machine? NF stands for No Flow. Check to see that your valves are open and that water is getting to your washer. If you have water to the washer, you my have a problem with the selenoid ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions
