SCSI ID and the tape drive SCSI ID at the front panel: Use this option to view or change the SCSI IDs used by the autoloader. The autoloader occupies two SCSI IDs, one ID is assigned to the autoloader
...SCSI ID number switch at the very back end of the scanner. Before changing the SCSI ID switch make sure your scanner is powered down. Repeat steps above when trying different SCSI ID numbers to see ...
...SCSI ID issues? I have assigned the SCSI ID's of the drives, and the library both physically (back of the tape drive) and via the OP panel, however I continue to run into issues where the system ...
Question about Power Mac G5 Desktop
...SCSI drive to an open (unused) number to avoid conflicts, reattach, this should eliminate the conflict. The DIP switch number equals the sum of the numbers you have set the switches to, so if you ...
...SCSI ID of each hard drive can be set from 0 to 7. The ID setting on the hard drive is jumpered by 3 x 2 pin configuration using a binary configuration to get the 8 SCSI ID combinations. Depending ...
Question about Power Mac G5 Desktop
...SCSI ID. Your SCSI controller is usually SCSI ID 7 (not sure why) but you can usually remove all the jumpers and that would be SCSI ID 0. you can have as many hard drives attached to your SCSI ...
...SCSI ID device boot device.. The hard drive needs to have the jumper set to SCSI ID 0, the CD and FDD can be set to SCSI ID 1 and SCSI ID 2. No SCSI devices can have the same SCSI ID number unless it ...
Question about APD-29160 MAC 64 BIT PCI SCSI ADAPTER 1870600 1870600 (APD29160)
...the scsi utilities section scan the devices if it finds it then check the id of the device how much its set to it should not be the same of the scsi card id .by default scsi card id is 7 but be
...jumper setting on the converter. --- Samaresh To make the first SCSI hard disk the boot drive, set the SCSI ID to 0 (zero) and the other SCSI hard disk as a slave drive set the SCSI ID to 1 or ...
...SCSI ID. Each SCSI device must have a different ID. The jumper/s are set for the following positions across 3 pairs of pins : : : = SCSI ID = 0 no jumpers - usually for the boot hard drive : : I = ...
Usually answered in minutes!
19,138 Questions
12,216 Questions
7,310 Questions
7,277 Questions
5,472 Questions