Question about 77 115 Intellisensor Plus Stud Sensor
How to operate the Stanley Stud Finder Hi Gene, Place the unit flat against the wall. Press and hold the button. The LED will come on for a second or two then go out. Slowly move the unit laterally ...
bostitch staplet leaking air at the top. I took the black bumper off and removed the black top four screw. I noticed that there was not a felt or any kind of gasket here. Next the three screw that ...
I have plaster walls in an old house the stud finder just keeps beeping how does this thing work? Your stud finder keeps beeping because old plaster walls have lath boards behind the plaster that are ...
Question about 77 115 Intellisensor Plus Stud Sensor
red light would not go out and beep would not stop when moving finder across wall. I had this problem as well. The solution was to replace the 9 volt battery that it runs on. The beep was much louder ...
Question about 77 115 Intellisensor Plus Stud Sensor
instruction for Stanley FatMax Stud Sensor Finder 400 (77-730) how to use stud finder Please people dont waste your money but a cheap standard one Stanley 77-730 stud finder is bad does not work at ...
stanley fatmax s300 manual s300 stud finder Go to http://www.youtube.com/watch?v=QInszVD9WpE&feature=youtu.be - doesn't tell you everything, but better than the manual Stanley ship with the ...
how to use a stud finder The stud finder works by picking up density of the product it is pressed and slid on..Turn your stud finder on make sure the ok light is on...then slightly press it against ...
...Move the magnet back and forth against the wall, slowly... until it sticks to one of the ferrous screws hidden in the sheetrock. These hidden screws are holding the wall board/sheetrock onto a
Question about 77 500 Intellilaser Pro Stud Sensor & Laser Level
Stanley stud finder AC sensor continually beeps on 10mm plasterboard wall Most stud finders have a sensitivity adjustment that should be carefully adjusted per instruction manual before use. Failure ...
Question about 77 500 Intellilaser Pro Stud Sensor & Laser Level
on Stanley stud finder model 77403 light goes on along with sound all the time button is pushed Possible low battery.
Usually answered in minutes!
20 Questions
11 Questions
26 Questions