...fell off..the plastic piece behind the vent will need to be replaced.. Can this easily be done..can I buy the part/s and do it myself? This should be a very easy fix. I assume you are talking about ...
...fell out. now the handle is, well duct taped on! I need help opening the door casing to re-screw the bolt into the handle. THANKS! You can find an exploded view for model PLM168 (it's probably very ...
...Screw fell inside door panel. How do I open panel to reattach and/or tighten door handle? To access the door handle mounting screws on MOST microwave ovens, you have to remove the inner door panel ...
Question about Spacemaker JVM1740 Microwave Oven
...into the microwave above the range and the nut fell off in the microwave. Can the nut be fixed or replaced? Use a magnetic retriever to to recover the nut , then use super glue to fix it back in ...
Question about MH1150XM Convection/Microwave Oven
...screw fell down in to the door and the class panel outside came loose. I also noticed the bracket the holds the glass plate on both sides are broken....who do i repair? Normally you have to separate ...
...fell off my Whirlpool Microwave Hood Combination - GH9176XM. How do I access the bottom screw for the door handle? Thank you You cannot. you would have to take the door apart and it's really really ...
Question about Advantium 120 Convection/Microwave Oven
...fell off and I need to reattach it take off the top vent cover , should be three screws ...hang the door provided nothing is broken off the door or the microwave.. after hanging put the vent cover ...
Question about SMH7178STD Microwave Oven
...screw to get it out and it fell inside the microwave. How do I remove the cover of the microwave to get inside to get the screw out there should be screws around the back and at the front corners at ...
Question about SMH7178STD Microwave Oven
...and one of the mounting nuts fell into the unit. Can this be easily repaired or do I need a new unit? Would this be covered under the warranty? warranty it manufacturer defects not installers screw ...
Question about SMH7178STD Microwave Oven
...screw fell onto the circuit board, and may short out when plugged in and turned on. The top and sides of the microwave are most likely one piece, and held in place by screws on the back and at the ...
Usually answered in minutes!
3,405 Questions
567 Questions
285 Questions
308 Questions
275 Questions