Handset and put the battery back without releasing the buttons. (now your in test mode) - press the 2 softkey below the screen ( it's a factory reset, erase everything) - You will see RAM/EEprom erase
...Screen says "registration failed"...any advice??? THANKS! Take battery out of handset for one minute. Unplug base unit (power and phone line) for one minute. Plug base unit back in (power and phone ...
...screen will display OTHER HANDSET ON and then OR OUT OF RANGE. You might press PHONE or SPEAKER again until no other handset is using the line. Use the call transfer feature to transfer a call to ...
...screen, this indicates that the handset has lost its link with the base. The following procedure should be followed to help resolve the problem: Confirm that the power lead has not been inadvertently ...
Question about DECT 6.0 Digital Cordless Phone
...handset screen. DO NOT FOLLOW THE ON SCREEN DIRECTIONS. Next place the Handset on the base station and press the find handset button for 4 secs until the In Use light shows up. Remove the handset and ...
...screen appear E4 and it didn't respond to any button when i press. I read some help which they say press 3 button " DND - * star - and top left silver button" to make an hard reset ...
...screen serching The phone is looking for base. You need to register the handset to the base Had same problem and tried the "Register Handset" solution but got display message "Out of ...
...handset screen does not show LOW BATTERY or HANDSET X, you will need to charge the handset for at least five minutes before registering to the telephone base. To register a handset: Place the ...
...screen indicate "searching"? how to get dial tone? The handset cannot communicate with its base. When the handset cannot establish its secure (encrypted) radio link with the base it is 'paired with' ...
Question about DECT 6.0 Cordless Phone
...screen read "Please wait". The registered handsets should read "Out of range or no power at base" until the deregistration is complete. Then you should see the message "Press Hold on base for 4 ...
Usually answered in minutes!
3,453 Questions
1,326 Questions
1,157 Questions
1,197 Questions
607 Questions
