scanner head failure. Unplug unit from computer to see if it will do it with no cominication to PC. i had the exact same problem. this fixed mine. http://h10025.www1.hp.com/ewfrf/wc/document?lc=en&
...scanner head starts to move at all when you power up the unit. If the head does not move at all or makes an unusual noise, chances are the unit is complaining that the head is stuck or requires too ...
...scanner head (the block that is stuck-- that normally moves) back to the starting position. Make sure its snug at the end, a little bit off and you'll be putting it have to take it apart and back ...
...scanner rail (silver round bar running width if printer that head with ribbon runs on) can get dry making head stop, lube with light machine oil. Canalso be from a faulty ribbon, the ribbon is driven ...
...head. Any suggestions? I dont think the paper is beneath the ph. Some paper will stuck between the gear wheels. Pull papertray out and try to look from the bottom into the printer. Another way is to ...
...scanner and see if the home position sensor, which would be a U shaped sensor has popped out. The clicking is from the scan head trying to find the home ( start) position sensor and not finding it. ...
...scanner head is unable to find home position. You will have to clean the strip under the glass. If this only start to happen recently, you could unplug the printer and wait 1 hour. Replug in the ...
Question about CanoScan LiDE 500F Flatbed Scanner
...scanner without locking the moving head, when starting the 1st time it stuck in the middle and makes a hig-pitched whine (motor strugging?). It there a way to manually release and move the head home? ...
Question about CanoScan LiDE 500F Flatbed Scanner
...stuck there. lift up the scanner unit and switch on the printer, does the sound come from the print head side, it could be due to the print head getting stuck... the encoder belt might be
Question about Scan to Web 5000U Flatbed Scanner
...head. Others have a protruding "pushbutton" on the bottom of the scanner, and when the scanner is put on a flat, hard surface (desk top), the weight of the scanner pushes that "button" up, releasing ...
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions