Questions & Answers for: Mini Cooper sauna heater

overheating i have a mini cooper s 02 plate. when driving temp gauge went up over half and cold air came out of heater when switched onto hot air. Posible thermastat sticking closed. If thermastat ...

heater not working in mini thermostat might be faulty? where is the thremostat in a mini and is it a big job to replace it I don't think it will be the thermostat, as this controls coolant into the ...

Y reg(1982) austin mini 998cc, when the heater is switched on the fog light switch lights up but heater fan does not start, fog light doesnt work either, have tried changing the switch but no ...

my 2003 mini heater is not blowing hot air when the engine is hot Either the thermostat has gone or the heater core/ heater matrix! needs replacing. this is coomon on these new mini's get the ...

how to remove/replace heater core 2003 R50 MINI Cooper If it is necessary to remove the heater assembly, the cooling system must be drained before removing the heater core. When a heater core leaks, a

...car and hold revs at 2000 rpm for 2 minutes with fan on and heat at maximum. If it dont feel like a sauna now, repeat the process. Then allow the engine to run till normal temp and observe that the ...

Not enough heat in cabin Running ETC is always between thermostat opening and closing range It's common to see the mini heater cores clog up a bit and deliver poor heat. Most likely you need a new ...

heater not blowing hot My Heater is not working in the car My 2006 f-150 4.2L 113,000 miles heater blows cool when at Idle ,But when driving the heater blows hot. Change thermostat change water pump ...

Temperature gauge on max,very little heat coming thorough heater system No coolant leaks,temperature gauge reading max,no coolant temperature warning light coming on,cold air coming through bulkhead ...

can you install a block heater 2012 mini cooper There are companies that make an aftermarket heater that replaces the factory dip stick, as long as your dip stick tube is straight. If your tube is ...