Question about 3 x 24" Belt Sander
...sander wont start has the brushes worn out how to swap them I've had this sander for years and it has been very reliable.Now though it just wont start.'m wonderng if the electrical bushes heve worn ...
Question about CP864 Dual Action Air Sander
on a cp864 the throttle is wide open ,, wont shut off the throttle wont shut off i think i nbeed part# 124233 where can i get it? http://www.airtools.com/catalog/ItemListView.aspx?id=148 try this
Question about CP864 Dual Action Air Sander
...wont work with air compressor, and shoots out air and the sander does nothing Normally when the air will not drive the tool, it is because 1- the tool is rusted up inside, 2- there is no lubrication ...
Question about 7800 Drywall Sander With Dust Collection
Sander was running and then just stopped running and now it wont turn on. Does not smell like it burnt up there was some dust in the moter, but i think thats going to happen. I had the same problem ...
Question about 7800 Drywall Sander With Dust Collection
wont turn on,if I tap the sander with a hammer then they start to work or sometimes not at all it can be ascertained, there is a problem in the switch or the motor carbon brush, carbon has been eroded
Question about 332K Quicksand Random Orbit Sander W/ Case
wont start unless i turn it on its side? It sounds to me that you have used the sander a lot and the vibration has broken a wire or it’s about to break on the field windings. The brushes you
how do you keep the belt from sliding into the sander and cutting into the sander itself? theres a adjustment screw on the side to adjust so it wont move side to side
SANDER DOESNT ROTATE MOTOR COMES ON, BUT BELT WONT MOVE Check to see if the drum is turning. If it is you need to tighten the belt tension and adjust for runout. If not you have a more serious problem
Question about BR300 3''x18'' Belt Sander
...sander will have a very smooth pad almost shiny if it takes stick-on discs (PSA). If not it will be a velcro pad and in that case you need the velcro discs. This description sounds like you have a ...
Question about BR300 3''x18'' Belt Sander
I have a cantek C251 sander and the paper wont stay on Need proper adjustment
Usually answered in minutes!
191 Questions
163 Questions
151 Questions
96 Questions