...ballast itself causing the issue. Samsung is well aware and will replace both the ballast and the lamp (since the lamp can be prematurely aged but the bad ballast). After replacment most people stop ...
...Samsung DPL HLN5065W and when I power it on it does the following: - Stays on for about 30s with audio but no picture - Goes off by itself - Comes on again same - on for 30s - Goes off by itself - ...
Question about HLN5065W 50" Rear Projection HDTV-Ready Television
...ballast itself causing the issue. Samsung is well aware and will replace both the ballast and the lamp (since the lamp can be prematurely aged but the bad ballast). After replacment most people stop ...
Question about HLN5065W 50" Rear Projection HDTV-Ready Television
Samsung HLN5065W Lamp won't stay on. My set will only stay on for a couple of minutes, then the lamp turns off. If you try to turn it on it cycles on and off with sound only.The lamp will not turn on ...
Question about HLN5065W 50" Rear Projection HDTV-Ready Television
samsung hln5065w dlp blows bulbs samsung hln6065w blows dlp bulbs. someone said the board may be bad. what components are known to cause this on this model? The N series, needs to be told via service ...
...Samsung 50" projection DLP TV, Model hln5065W, the set won't turn on, the green light blimks 36 times the first time, then shuts off, turns itself back on, blinks about the same amount of time, shuts ...
...Samsung hln5065w dlp tv went blank. When I turned the tv back on after trying to reset it there was a winding noise but no picture. I replaced the lamp and still no picture. The timer-lamp-and temp ...
Question about HLN5065W 50" Rear Projection HDTV-Ready Television
Samsung HLN5065W will not start up. Goes through 3 cycles and then lights in center circle blink. A new lamp was installed 2 months ago and it worked fine. The first time it didn't start-up, I ...
Question about HLN5065W 50" Rear Projection HDTV-Ready Television
...samsung HLN5065W dlptv. My wife turned it on one night and no picture. we did get sound. i noticed when I turn the tv on, it shuts down and restarts to no avail. I see a blinking lamp light and after ...
replacing ballast how do you find bad ballast? Hello, You would need to test the voltage coming to the ballast which depending on the ballast should be at least 320V but nothing higher than 370V maybe
Usually answered in minutes!
2,410 Questions
2,254 Questions
1,646 Questions
1,423 Questions
1,438 Questions