...safety belt. 5. Place the parking lamps/headlamps switch in the OFF position. Deactivating/Activating 1. Turn the ignition switch to the RUN position. (Do not start the engine.) 2. Wait until the ...
Question about 2004 Explorer
...safety belt, or simply unplug the harness located at the seatbelt receptacle. Sorry, I do not have the owner's manual. But, here's the step by step directions for turning off the "Belt-Minder." One ...
Safety Belt Warning When the ignition switch is turned to RUN or START from OFF or ACC, the chime will sound for six seconds or until the safety belt is buckled. The safety belt warning indicator lamp
Safety Belt Bolt Bit T77L-2100A NOTE: Safety Belt Bolt Bit T77L-2100-A should be used for safety belt removal and installation. Removal Remove rear seat cushion. Refer to Section 01-10 . Seat Cushion,
...safety belt warning light turns off. (Approximately 1?2 minutes.) ? Steps 3?5 must be completed within 60 seconds or the procedure will have to be repeated. 3. Buckle then unbuckle the safety belt ...
...safety belt warning lamp turns off (approximately 1 minute). NOTE: Step 3 must be completed within 50 seconds after the safety belt warning lamp turns off or the procedure must be repeated. For the ...
...safety belt buckle electrical connector. Remove the front safety belt buckle.NOTE: The front safety belt buckle retaining bolt is part of the safety belt buckle and should not be separated. ...
Question about 2002 SVT Focus
...Safety Belt Warning Indicator Lamp and Chime The safety belt indicator and chime feature is controlled by the CTM. The driver safety belt switch is hardwired to the CTM. If at any time during the ...
Question about 2004 Expedition
safety belt buckle pretensioner electrical connector or passenger safety belt buckle pretensioner electrical connector of the affected seat and CONNECT restraint system diagnostic tool 418-F395 to the
Usually answered in minutes!
687 Questions
481 Questions
236 Questions
236 Questions
240 Questions