Questions & Answers for: Ford F-150 run about

Tailer running lighs dont work I have an f-150 2004 truck while I was checking my horse trialer lights I shorted one of the runnig lights to ground. I now have no running light power to my trailer ...

trucks runs on back tank, won't run on front tank on back tank, can hear fuel pump and truck runs. switch to front tank won't run - can hear relay click but don't hear fuel pump. most likley the fuel ...

90 f150. when i switch to the rear fuel take the truck runs for awhile then dies,(like its not getting fuel) i can flip the tank switch to front tank then back to rear tank and it will continue to run

1997 f150 starts runs ruf temp spikes dies turn key off 30sec sta restart and it runs fine untill it cools off then process repeats truck does not accualy overheat but gauge shows it does. Just had a ...

my 91 F150 is not running good and my mechanic can't figure out why. he's tried a number of the obvious things but still can't find a solution. it's hard to start but after running a while it runs ok.

1990 Ford F150 wont stay running, replce ECT and ICM ... still wont run. Water coming out of exhaust after trying to run. 5.0 w/5-speed. Very possible bad head gasket and fowled out plugs and/or O2 ...

91 4.9 won't run with spout in, runs with spout out. Truck would not run. Installed new dist. and control module. Pulled spout, set timming to 10 degrees. Engine ran smooth. Plugged in spout and ...

1992 f150 5.0 302 very hard to start runs poor a minute or two then runs great. Whats the problem If it runs and I shut it off it starts fine but runs poor a minute. If I dont drive for several hours ...

Why does my truck start up and run for about 10 seconds before it dies? I The truck will start but l don't hear the fuel pump running.Shouldn't the fuel pump run all the time the ignition is on? It ...

My 2005 Ford F-150 hit a small wall at 10 miles an hour and now she won't run. It cranks but that's all. Please help Recently replaced fuel pump and filter. I pushed down the reset button by the fuse ...