...sticky it was(did not want to come out easy and therefor especially not back off) decided to replace calliper (expensive but life time warranty) to keep life simple. I like the design, very easy to ...
Question about 1999 Silverado 1500
...Rubber Seal on the New Handle or it will leak! For the Inside Handle- Remove the Pin connecting the Old handle and Replace with the New once you get the Door Panel off it is Really Easy from there
...rubber grommet seal and disconnect wire at connector, careful that other end does not pull back in, i tie string on it before disconnecting so i cant loose connector inside. then close hatch and ...
...rubber boot/cover at the base of the e-brake handle if you can. on most cars there should be "teeth" that engage on another set of teeth. the "button" at the end of the handle should be spring ...
repl door handle on 1999 chevy astro van right door can not get to upper bolt to remove old handle should be a rubber plug on the end of the door
Question about 1990 Suburban
...handle pulls out but wont release hood. Try pulling on the hood release, while someone else lifts the hood. If this doesn't work. You can access the underside of the hood release by taking the front ...
...rubber bumper that stops the gas pedal from coming up too far, it gets sticky and holds the pedal, you have to stomp on it to free it and then it is ok for a while, I sprayed mine with wd40 a few ...
...sticky so be ready for that ,, look inside the access hole, you will see the arms with the plastic tabs that hold them on the handle , those need to be removed, after that ,, look for the 2 screws ...
...handle nut thru the rubber plug on the side of the door.can't get to the top nut-no plug for that one On my 95 Astro, I use a 10mm ratching box-end wrench with a flexible head to get the top ...
Usually answered in minutes!
4,236 Questions
3,219 Questions
2,541 Questions
2,307 Questions
2,177 Questions