Questions & Answers for: Honda VT 1100 C2 Shadow Sabre rubber become sticky

Looking for the rubber spacers for the 2 front Winkers.They have dried up & split. contact a honda dealer and they will get you the parts you need

...out? Thanks. Pull harder or gently pry with a screw driver. The only thing holding it on now is a rubber o-ring and a spline shaft. The two bolts you took off are the only thing that hold the ...

...the tank. These just pull off, they are attached the same way the side covers are with pins and rubber grommets. Anyway pull the left cover off, (Left if your looking at the bike from the front), ...

rubber diaphragms have holes in them or have become sticky they need to be replaced. Air cut diaphragms turn off the fuel during deceleration to prevent back firing. If they go bad they can cause poor

...it, sorta looks like a bubbled triangle above the exhaust. It has 2 plastic clips that pop in to rubber grommets. I'm not sure on that year, you may need the key to unlock. Some older models also ...

...VT 1100 INEED TO CHANGE MY BATTERY.I WANT TO KNOW HOW TO CHANGE IT. Pull the side cover off the rubber grommets , unbolt the bracket covering the battery, unbolt the terminals , and remove the ...

i have a 96 shadow ace 1100- when i down shift and try to go go the bike wines out like the cluch is slipping- I let off a little and it grabs'''??? is my cluch bad --can that be ajusted More than ...

how to remove a float bowl on honda vt1100 As I start up my motorcyle gas spews out the rubber hose on the left side of my bike. I read on another post that the float bowl needs to be taken out and ...

...bladed screwdriver between the rotor and the piston side of the caliper. Next, remove the small rubber plug on the lower side of caliper and then remove the 5mm hex head screw. Once the screw has ...

...replacement part online or from a local Honda dealer. The filter is in-line on the fuel hose (rubber hose coming from fuel tank). It has an inlet and an outlet - be sure you install it