Questions & Answers for: Pentax rubber become sticky

...rubber bumpers and gaskets in the mirror mechanism that have a tendency to turn into sticky gooey sludge causing the levers in the shutter and mirror mechanisms to get sluggish. The latch that tells ...

rubber bumpers and gaskets in the mirror mechanism that have a tendency to turn into sticky gooey sludge causing the levers in the shutter and mirror mechanisms to get sluggish. The only real solution

rubber used in the mirror gear which has softened and become sticky. If you leave it too long before uses it may jam good, with the mirror in the flipped position. If this happens do not try and force

...rubber bumper next to the fresnel lens has become sticky. very gently ( after removing lens ) try to bring mirror down without forcing it. it should release easily. if not, rotate the select knob off ...

Film Advance Problem I recently got a pentax k1000, the film advance works fine when there is no film in the camera (or if there is film in there and the back is open) but once I close the back the ...

...until the two stars become one. Use a little bit of rubber cement to hold the rubber back in place. Rubber cement will allow you to peel rubber back again in future should you need to adjust

...become gunged up. This is not an easy repair for a beginner. The rubber has to be removed from the body of the binocular before you can even start to take them apart to determine the fault. Like any ...

I have a Pentax ME Super that, after sitting for a couple of days, double advances before it catches. After that it works fine until it again sits for a day or two, and then it does it again. Any ...

...BECOME STICKY.TELL IF THERE IS ANY SERVICE CENTER IN PUNJAB INDIA Hi there i like to inform you that its a lens guide pin problem. It is damaged or out of lens guide line. Thats why its stuck. The ...

...sticky and I would like to lubricate it K1000: Remove counter cover (3 setscrews around perimeter), remove counter disk (screw is right threaded - turn right to remove!!!!!), washer if not glued to ...