...rotary button. ECM should be lying flat in bottom of distributor. Wires will be running to it. Again BE CAREFUL. Dont distroy connectors or wires. Replacement of ECM module is as simple as removing ...
rotary and pick up, idle air control valve, starter relay, starter, and put a new battery on. I think the timing is off but it ran a few times before this with the timing being off. It's getting spark
...rotary button. I used to be able to turn the ignition on and off real quick and it would start, now this doesn't even help. Once it starts it would continue to start fine the rest of the day. Any ...
...Rotary Engine. For the 1.1L Firng Order: 1-2 (thats all folks!) Cylinders: __________ |......2.......| |......1.......| ....[FAN] Distributor: .............(+)-screw ......2 1..........2 ......1 ...
...Rotary Engine. For the 1.1L Firng Order: 1-2 (thats all folks!) Cylinders: __________ '......2.......' '......1.......' ....[FAN] Distributor: .............(+)-screw ......2 1..........2 ......1 ...
...rotary and distributor cap. It starts and idles with a slight miss, but misses badly when I push down the gas (in neutral and in drive) and has no power. This car was running fine before the CPS ...
...firing order is reversed but still starts from No 1 cylinder , these type of engines are not widely used as like Radial and Rotary engines they are more technical to engineer and so are more ...
...Rotary Engine? Most rotary engines require a different type of ignition coil pack. Below are two, one for a standard replacement, and one that is a higher voltage performance type coil pack. Original ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions