Questions & Answers for: roper washer water shut

washer won't run washer fills with water then it basicly shut off it won't spin,rinse or wash after it fills first check you lid switch let me know..

...washer is in the stop position, but water continues to fill. My mom has the same issue with a Roper top loader. Her home uses water from a well. She had problems with the pump and had it replaced. ...

washer I have a 2 yr. old roper dishwasher which worked just fine untill 2months ago. the water line is ok to the unit but does not get inside altho it goes thru the cycle. is it the pump or a plugged

...roper washing machine under fills when put on large load. is there a fix for this problem? Yes. This is caused by a faulty water level switch. This is a diaphragm like device with a small clear ...

...rotate but when it gets to spin just shuts off" Most likely it is the valve that opens to let the water drain from the washer. located on the back just replace ot and this should solve the

...water is turned on (from house to washer) it run continualy. even whe tub is full. cold will shut of normally, hot will not! Help! Good day, If you unplug the machine from the wall and the hot will ...

...washer with too much weight it will not drain also if you use too much soap it will cause a roper not to DRAIN this has happened to me check your drain line make sure it's properly installed ,take ...

...Roper will not allow hot water in although the supply is hot This sounds like your water valve may have failed. They are fairly easy to change, and are not very expensive. Where the water lines come ...

roper washer The washer filled up water but did not start spinning. That could be your lid switch. You should hear an audible click when you shut the lid. If the washer act like it is trying but ...

Roper tp load washer filling too fast, won't stop filling. I shut it off, then tried to spin to get water out. Won't run on spin. What could be problem? Most likely either water valve is bad or ...