Questions & Answers for: roper dryer moisture sensor

...Roper REX4634KQ1 Electric Dryer When I use my dryer the dryer does not get hot enough to dry my clothes. It feels like it gets warm but not hot enough to dry clothes. I have to run clothes through 2 ...

...dryer and clean the **** off the 2 strips of metal in the back called sensors. Next get the rear of the timer panel off and yank out the small computer board next to the timer. This is the moisture ...

...the dial and shut off the dryer when the clothes are dry. This is a Roper base model 2 years old. Would vacuuming near the sensor solve this problem or is the sensor not working? check for

...moisture sensor and how do you replace it? My mother has one of these machines. Less than a year old. I think that is just the nature of these dryers. The vent goes right through the wall and is a 2 ...

...Roper Dryer it will not heat and timer will not turn off. THe handle turns it on but not off How old is this machine and are the clothes dry and still running.? Is there a moisture sensor on this ...

dryer wont dry all the way like it used to. Have to run it through a second cycle?? Could it be a moisture sensor? It could be if you have it set on Auto dry the thermister is not working properly.But

...Roper dryer takes for ever to dry on auto but works fine on timed lowest setting. I'm thinking the moisture sensor. I found the location of the sensor for a front lint trap, but this is a top ...

...roper dryer works fine, it heats and the timer advances, it just wont shut off at the the end of a timed dry or auto dry. What do you think? I haven't done much yet, just started happening. A timed ...

...roper dryer starts runs few min. Then stops Starts then stops ELECTRIC Dryer no heat or little heat, or shuts down to fast: Check your venting and lint basket. Check blower for lint build up and ...

roper model red4640yq1 heats in auto mode but not on timed dry model RED4640YQ1 Lastly check your moister sensor. ( located inside the dryer door usually) Especially if machine seems to shut down ...