...roll pin. Install a roll pin remover/installer tool (they always get u with that darn special tool, don't they?) or equivalent set up. Pull the roll pin out of the intermediate coupler. Separate the ...
...roll pin that holds the pinion pin in place has sheared off . you'll have to try and get the old pin out and insert a new roll pin. This is a common problem with caravan transaxles. Hope this helps ...
shifter want go into drive, stuck in park parking pin may be bent from putting into park while still rolling had same issue with a 92 blazer so what can i do
...blue strip. I have ground to pin 4 black wire. Does the roll over line need to be connected for the fuel pump to work. please go to a parts place and buy a haynes manual-theyre detailed in all ...
...wires.turn key to accesory and with a punch push roll pin back in hole enough to clear the casing for the key lock cylinder.pull out clinder and put it in the new switch then turn to on to lock
...lever and the actual transmision' Could be as simple as a connecting pin has fallen out So therefore the car is still in park and won`t roll Hope i have been of some help John (South Wales
driver window wont roll up If you have power windows it is your heat sensor on the motor. this can be fixed by taking the motor out (tedious job) and taking off the heat sensor (a piece of metal that ...
transmission rolls freely in park, locks up like in park in all other gears. Inside the transmission there is a pin that slides into a gear to lock the transmission when in park. It sounds like this ...
...roll-pin style you should be able to remove it up or down. (if you don't have a punch! a phillips screwdriver, another bolt, a torks screwdriver, etc would work, just needs to be slightly smaller ...
parking gear does'nt hold the van from rolling/ parking gear does'nt hold the van from rolling/ check the linkage the pin may have come out
Usually answered in minutes!
2,271 Questions
2,049 Questions
1,788 Questions
1,616 Questions
1,496 Questions