Questions & Answers for: rod winding thread

Ad

Question about 7422

1 Answer

...to engage motor. Then try. Most of the time people forget to push the bobbin winder pin/rod to the right which leaves the machine in sewing mode rather than in bobbin winding mode. Easy mistake.

Ad

...rod mark the thread on the rack side, then its a matter of removing the split pin and loosening off the nut closes to the wheel then give it a good wack dont hit the thread once its free leave it ...

Ad

Question about 5050 Mechanical Sewing Machine

1 Answer

...winding thread onto the bobbin. Position the new empty bobbin onto the vertical bobbin rod next to the end wheel. Click the rod to the right to engage drive. Hold the outer end wheel with left hand, ...

Question about 5050 Mechanical Sewing Machine

1 Answer

...winding thread onto the bobbin. Position the new empty bobbin onto the vertical bobbin rod next to the end wheel. Click the rod to the right to engage drive. Hold the outer end wheel with left hand, ...

Question about Featherweight 140Q

3 Answers

...winding thread onto the bobbin (small free- arm Singer 100 sewing machine). Once bobbin winder shaft is pushed to the right nothing happens-bobbin rod does not start turning so I cannot wind the ...

Question about Featherweight 140Q

1 Answer

...to use to attach these metal feet to the wall or how deep will I have to drill and use a threaded rod to aquire sufficient strenght to stop the up draft effect from lifting up the awning. Hope you ...

thread things and the assembly will be kaput. Offer the rod up to the connecter at the foot pedal and the shift arm and gently screw in each end at the same time. Make sure that the threads match!! ie

Question about 2004 CMX 250 Rebel

1 Answer

rod to keep it from unwinding any more Release the 2nd cable spool and thread the other side cable. Turn the spool to have the same tension as the other cable. Then wind the spring about 6 revolutions

Question about 2002 Chevy Corvette - Z06, 6-speed manual, 5.7L V8 LS6 - Performance Module

1 Answer

clutch adjusting how do you ajust the clutch? Check for a threaded rod at slave cyl. or it might have a cable with a thread ,pull cable away and wind nuts inwards.

Question about 2002 Chevy Corvette - Z06, 6-speed manual, 5.7L V8 LS6 - Performance Module

1 Answer

...Other machines make you move the rod that the bobbin sits on for winding move or swing to engage the gear. There should be a path for it to slide along if that is what your machine does. Good

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Sewing Machines Experts

Cindy Wells

Level 3 Expert

6164 Answers

Chris Wetmore

Level 2 Expert

190 Answers

Marvin
Marvin

Level 3 Expert

85239 Answers

Are you a Sewing Machines Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...