rio need to replace knock sensor/ O2 sensor, dont know location or degree of difficulty IT IS IN THE SIDE OF THE ENGINE BLOCK, SCREWED INTO THE WATER JACKET OF THE BLOCK O2 sensor is in exhaust system
...Rio the knock sensor is located under the intake manifold and must be changed from underneath the car. If you remove the oil filter it is directly above it and is in clear view once the oil filter is ...
...knock sensor is located on a 2001 kia rio. need to replace knock sensor but dont know where its located on a 2001 kia rio. At center rear of engine compartment, by intake manifold support
knock sensor located on 2003 Kia Rio 2003 kia rio, It is located under the intake manifold. Get underneath the car, pull the oil filter...it is right above it and in clear view with the oil filter out
...knock sensor located on a 2003 Kia Rio and is it hard to get to? Turn ignition off. Disconnect knock sensor 3 -pin harness connector. Locate knock sensor, on cyli nder block. On Optima 2.7L engine, ...
knock sensor located at on 2003 kia rio 1.6l you have to take off the air cleaner box and its on the back of the engine you have to reach down between the fire wall and the mainafold it right there in
...Rio the knock sensor is located under the intake manifold and must be changed from underneath the car. If you remove the oil filter it is directly above it and is in clear view once the oil filter is ...
where do I locate a knock sensor on a 04 kia rio look under the intake manifold on the cylinder head
...knock sensor located on the engine of 2003 kia rio? Take off the air cleaner assy and on the back of the engine by the fire wall under the exhaust manifold you will see a wire coming up going to a ...
Question about 2004 Rio
...for a 04 Kia rio. It read the code P0325 (knock sensor)& P0101 (Mass Air Flow Circuit/Range performance problem) Neither of those codes depend on a bonding strap. Replace the MAF and the knock
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions