...vent hole. Check for any impeller rubbing inside pump, and for loose or rough bearings. Installation: Clean all gasket and "O" ring surfaces. Install NEW "O" ring on water pipe (wet "O" ring with ...
vent tubes if any.....with a helper, slowly remove the tank from the filler neck tube and lower the tank...once tank is on floor, allow for lots of ventilation...there should be a locking ring holding
...vent, p/n 05017800AA, in place of the removed sealing dart. Slide locking ring back into place. Attach the connector back on the oil pressure switch. Spot tape the wire/vent to follow the harness ...
...vent o-ring seal Possible Solutions: with a P0442, the most common repair is to: Remove and reinstall the gas cap, clear the codes, and drive for a day and see if the codes come back. Otherwise, ...
...of connector to gain access to terminal locking tabs, install wire terminal vent part# 05017800aa in place of the removed sealing dart, slide locking ring back into place, attatch commector to ...
Question about 1996 Sebring
...all the way down into the filler neck? You can hang the end of the nozzle from the last 2 or 3 wire rings around the nozzles exterior, with out it falling, but don't leave it unattended. If this ...
Usually answered in minutes!
1,173 Questions
965 Questions
801 Questions
581 Questions
462 Questions