...ring on new pump and lube ring up with some kind of lubericant. A little oil, tranni fluid, even pertrelum jelly. Pump pump back in, when you push down on it to set it into place, make sure you push ...
pump and 0-ring seal from tank. Discard old seal and pump inlet filter. Installation Wipe seal area of tank clean and place a new 0-ring seal in position on pump. Before installing pump always install
...pump locking ring counterclockwise and remove the locking ring. On 1995?00 models, remove the retaining bolts around the perimeter of the fuel pump module. Remove the fuel pump/sending unit assembly. ...
...pump. The ring stops moisture and dirt from getting in the tank. If your o ring is craked it could cause your jeep to run a little rough. I'm having the same problem in my jeep. I can not put the ...
...pump locking ring counterclockwise and remove the locking ring. Remove the fuel pump and bracket assembly. Remove and discard the seal ring. To install: Clean the fuel pump mounting flange, fuel tank ...
...pump locking ring counterclockwise and remove the locking ring. On 1995-00 models, remove the retaining bolts around the perimeter of the fuel pump module. Remove the fuel pump/sending unit assembly. ...
ring holding fuel pump in tank is corroded / rusty. Can't move it, are the tabs secured with slots OR by turning the ring will the slots move and tabs stay put?? I remove them with a flat punch ...
...pump module O-ring seal and discard. Installation NOTE: When cleaning fuel pump module mounting surface on fuel tank, use caution to prevent any foreign material from entering fuel system. Clean fuel ...
Question about 1996 Mystique
...pump. I thought I had an o-ring between the diffuser and the impeller ring when disasembling. I don't see the on the schematic however. I do find a raised ring of plastic on the diffuser in the ...
Question about 1996 Mystique
...properly im sure someone was in there if the o-ring is not seated properly the pump has a spring load on it u have to place o-ring, push pump down ,and either screw in or turn the lock ring ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions