need to know cylinder head bolt torque specs I have 1994 Oldsmobile Cutlass Supreme with 3.4 Liter engine. I am replacing the head Gaskets and need to know the proper torque specs for the cylinder ...
speaker mounting specs need to know the front door speaker specs to see if they match some speakers i have. jensen JS 65, 105 watts 1 and 7/8" mounting depth. thanks! well from what i can find on the ...
1995 cutlass supreme 3.1L rear is down low my stabiler bar is almost off on both sides cracked would that be the problem? Do stabilizer bars keep the rear up or is that the shocks? Stabilizer or anti ...
need the torque settings for a '94 cutlass supreme sl 3.1 in reference to the cylinder heads I need the sequence and the torque if possible a diagram 33ft/lbs left to right when looking at engine ...
what are the specs for the intake and head tork settings cylinder head bolts are torque to yield bolts and are not recommend to torque them a 2nd time you should replace the bolts. cylinder head blots
When I start car , it runs til I step off the gas Check your fuel pressure.If its not within the specs replace pump.
93 old cutlass supreme cuts off when put in gear after getting hot First check you fuel pressure it should be 41-47 psi with key on engine off.If its within the specs pull the crankshaft position ...
...ride height and the shocks will keep the rear end from bouncing all over the place. You may have struts in the rear and if so then these will have to be replaced as a whole unit. After this is done ...
What is the minimum brake roter thickness for front roters on a 1994 cutless supreme this is stamped on the rotor, however sometimes you can`t read it. you can talk to a machine shop to get the spec. ...
Question about 1996 Cutlass Supreme Coupe
what is torque specs for 1996 olds 4T40-E pan bolts transmission pan bolt torque 15-18 lb
Usually answered in minutes!
697 Questions
571 Questions
488 Questions
387 Questions
236 Questions