Questions & Answers for: riccar hose clog

...To check there, take off the bottom plate and check the lnlet. If in the hose, you have to use something to pull it out. Use a flashlight to see down the hose and see if you can see a clog or

...Riccar 8850: To reset the thermal fuse: Unplug the vacuum cleaner Check for problem ? over?filled bag, clog in hose, clogged filters, etc.Remove the vacuum bag, and see if you can visibly see any ...

Suction not working If suction is good at the canister but not at the end of the hose you must have a clog in the hose

loss of suction Your vacuum may have a clog in the hose or in the tube where the hose inserts into. Make sure to replace the belt it it's been over a year.

Riccar upright vacuums. If the hose has good suction but is not picking up well check the suction tube that is down by the brush roll. The suction tube starts by the brush roll and goes to the back of

hose, however. I think you mean it's an 8955, Riccar has not had a 8995 model. If there is no suction in the hose it has to have something clogging it. Open the little round opening on the back of the

Riccar vacume lite for bag is on when bag is not full sometimes that can happen if the pores in the bag are clogged, as might happen if you have been vacuuming very fine dust like wallboard dust. this

poor suction, red light going on despite new bag, checked hoses and intake for clogs Red light on means a clog or restriction somewhere. Have to find it.

RicCar vacuum overheating If your Riccar is overheating you most likely have a full bag, clogged filters or a clog somewhere in the hose or vacuum tubes.

riccar 500 vacuum will not start. hoses are not clogged, bag is in corectly, do not see any lights on, tried reset button still nothing. will not start. The 500 model is pretty old. It could be a bad ...