Part # for a Y Sustain Board Cable Ribbon Board = LG 6871QYH039B Model = 50HP66 Plasma TV need to replace the cable ribbon connecting the Y Sustain board and the Top Y Drv board. For reference, the ...
Question about gigabeat S MP3 Player
...I took out all of the screws to the outer case (5), gently slid cover down until the small ribbon connector for the power buttons is exposed, unclip and remove. Set aside back of unit (at ...
Question about Satellite M65-S9092 Notebook
...pulling the screen forward toward closing until it works OK> Curtis Sounds like a problem with the ribbon for the screen being either having a loose connection or getting nipped. Pretty common on ...
...ribbon, the lens, the track slider. you know how dirty disks are if its not dirty or connection is good then check within your computer about format speed or write protection even for home made disk ...
keyboard ribbon connector on the motherboard need the retainer cable lock clip for the keyboard connection ribbon to the ribbon in to the motherboard connection Cut a piece of sturdy clear plastic ...
Question about Satellite A205-S5831 Notebook
...in case. I installed the paddle without any problem. When I put it back together, I plugged the ribbon back into the control board and slid down the two white locking slides for a straight and ...
Ribbon rewind does not operate, labels print but ribbon comes out the front of printer with the label? Have you selected thermal transfer in the driver? This is the normal cause for ribbon not ...
and make sure it is in fact plugged in. Make sure the cord is not bend or tore as well. I believe the cam cord is a ribbon cable. Not 100% on that. but you may not have it plugged in completely either
Question about Sm-352 Cd-rw/dvd Drive
...the cable from the motherboard (that has a 4 pin male connector) to the drive, or does ONLY the ribbon cable and the female power connector attach to the drive? I connected the ribbon and power ...
Ribbon Error 1 - Toshiba B-SA4T series I have fully calibrated the the printer, I also have done the sensor alignment for reflective. On the printer driver, I have selected Thermal Transfer. Every ...
Usually answered in minutes!
405 Questions
364 Questions
299 Questions
263 Questions
243 Questions