...Heater Model 206 for my pool. I'm geting a fault code( ROL-Heat roll-out safety switch open). How is the problem repaired. Heater has been working fine since end of May. John replace fusible link and ...
Question about Rheem Gas Fired Pool & Spa Heater Model P-m266a-en-c
rheem digital gas pool heater fan code rheem digital gas pool heater "fan" code????? also had "cfh" code heater worked fine yesterday, but won't work today. either wont ignite, or seems to ignite and ...
Question about 266K to 399K BTU Swimming Pool Natural Gas Heater ()
When I turn on my Rheem Pool Heater, I get a code SP5. What is it telling me? check gas pressure or see if on if ok check ignitor and safety circuit
Question about M406A 399K BTU Cupro Nickel Pool or Spa Natural Gas Heater
I have a Rheem 406 pool heater. the status code in the display reads " CFH" Call for Heat. The unit is not turning on . What is CFH and how do I reset the furnace? call for heat check ignitor
Question about Rheem Gas Fired Pool & Spa Heater Model P-m266a-en-c
...Rheem gas fired pool heaters SNS is a temp sensor failure. 1. Water temperature is below 36F or above 110F 2. If the two thermistors are more than 2 degrees apart, the SNS code will appear. 3. Loose ...
Question about 266K to 399K BTU Swimming Pool Natural Gas Heater ()
RHEEM POOL HEATER HL2 ERROR CODE high limit bad replace and check gas pressure
Question about 266K to 399K BTU Swimming Pool Natural Gas Heater ()
Rheem gas fired pool & spa heater with fault code ILO Getting a fault code ILO low limit bad
Question about 266K to 399K BTU Swimming Pool Natural Gas Heater ()
My pool heater digital Rheem P-M266A-EN-X Showed a code SNS I replaced the sensor and I still have the code sense no spark check ignitor
What does CFH mean What does error codeCFH mean on a themes gas pool heater this is not an error code. it means a call for heat. the pool water temp is colder than your tstat set point
Question about 266K to 399K BTU Swimming Pool Natural Gas Heater ()
rheem pool heater code ifault Turned pool heater to 90 degrees and shut off at 87 with error ifault too limit - why? check gas pressure if ok then turn up by calibration
Usually answered in minutes!
1,045 Questions
774 Questions
337 Questions
287 Questions