Questions & Answers for: Cadillac retaining ring

...retaining ring for the bulb to the front of the car. Do not touch the two headlight aiming screws, at the top and the side of the retaining ring (these screws will have different heads), or the ...

Ad

Question about 1988 Seville

1 Answer

...retaining ring has to be removed, hoses disconnected carefully, and the entire fuel pump assembly with the float & low fuel warning sensor (if equipped) will be removed . Important to note the ...

Ad

...retaining ring that keeps it in place. It will not come off from were its at and only when the axle is out in front of you. This axle simply is shoved in and gives out a load click when properly ...

...use the lock plate remover thanks for ur help its a 1989 cadillac coupe deville Must have a special tool to compress the spring so you can insert the retaining ring in the groove above the lock

...to twist loose then remove, and change out bulb. then reinstall socket. if u have an older car. just remove the retaining ring with a screwdriver thats around the replacement bulb / housing ...

Question about 1992 DeVille

2 Answers

...retaining ring and the coil assembly. Allow the coil to hang freely. WARNING The SIR coil assembly will become off-center if the steering column is separated from the steering gear and is allowed to ...

what can cause a window not to work on a cadillac deville, 2003.i have replaced the window motor/regulator assembly and the door module. i need to get wiring schematics for this vehicle. can u help me

Question about 1994 DeVille

1 Answer

ring is on the new sensor. Install the sensor and tighten the retaining bolt firmly. Do not over-tighten the bolt, as you will damage the sensor. Plug in the wiring harness connector, ensuring that it

Question about 2001 DeVille

1 Answer

...retaining bolt. Remove the crankshaft sensor. To install: NOTE Inspect the crankshaft sensor O-ring for wear or damage. If a problem is found, replace the O-ring. Lubricate the crankshaft sensor ...

How to Replace Fuel Regulator on 1990 Cadillac The fuel pressure regulator is located on the top of the engine and is attached to the fuel supply rail for the injectors. You unbolt the retainer tang ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cadillac Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Sean Wright
Sean Wright

Level 3 Expert

2045 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...